Category Archives: Bathroom

Jacuzzi Maintenance : A Short Guide

Hot tubbing in Keystone, Colorado.
Image via Wikipedia

When you’ve got your very own Jacuzzi, it can be easy to forget in the middle of all the relaxation and gentle bubbles that you need to dedicate a bit of time to maintaining your tub. Our guide gives you a quick ‘how to’ on Jacuzzi maintenance.

Firstly, make sure you have the right equipment. Jacuzzi surface cleaner, filter solution, bleach and a soft sponge are the most important things, helping you to keep the tub surface, filter and plumbing in great condition.

The most obvious place to start your cleaning is the external surface of the Jacuzzi. These are easy to wipe down with a specialist surface cleaner, which you can get from spa supply stores. Drain the Jacuzzi of water before applying the cleaner to all the surfaces and letting it soak so the build up of grime dissolves. Then use a soft cloth or sponge to wipe of the excess cleaner. Cotton buds are useful for reaching the tricky bits, and remember to take extra care around the jets.

Care also needs to be taken with the inner workings of the Jacuzzi so the pipes don’t get blocked. Fill the Jacuzzi with warm water and dissolve into it 2 teaspoonfuls of detergent and half a cup of bleach. Run the Jacuzzi for a couple of minutes until the water from the jets is clear. Next, drain the tub and fill it with cold water. Leave it for 5 minutes and then drain it again so the Jacuzzi gets a good rinse. Manufacturers recommend this should be done every 3 months.

While you’re cleaning the insides, it’s also a good idea to clean the filter. This is easy to do – remove the filter and then use water from a hose to give it a good clean. Mix up a solution of water and filter cleaner, following the packet instructions. Soak the filter in the solution for the recommended time, then take the filter out of the water and give it a rinse with fresh water before you put it back into position in the Jacuzzi.

The above steps will help your Jacuzzi stay in great condition and let you get years of use out of it without affecting your warranty. It’s vital to give it a good clean as failure to do so can result in infections from contaminated water, which is caused when scum, dirt, skin cells and oil cause scales to form and bacteria begins to breed.

A little bit of care and maintenance will go a long way to keeping you healthy and your Jacuzzi experience relaxing and fun.

Incoming search terms:

  • pictures of theinsides of a jacuzzi
  • short jacuzzi tub

How To Install Bathroom Sink- An Advice On Our Bath

Sink (Kobe_Harbor_Land)
Image via Wikipedia

At most of the interior decorating and bathroom remodel jobs we can find something which seems a bit too hard for us, but basically it is simple. The “How to install bathroom sink?” question is very frequent in bathroom remodeling. Installing a bathroom sink is not as hard as one might think. It becomes that much more easier once you get hold of the required techniques and skill. It will need only a proper learning prior to starting and a couple hours.

Hot intake, cold intake and the drain are the three major components of a bathroom sink. Drainage system can be recogned as the most important thing out of all. How to install a bathroom sink? Well you will have to make sure you access all these three departments and get them connected with the new sink you have brought in. Easier said than done, this process will require you to temporarily cut off the main water supply to the house or if you have a separate water inlet to the bathroom you can switch it off.

It will surely require some essential tools. A Jig saw, some caulking, a drill to make the holes for the bolts to be inserted and pipes to be planted, a crescent wrench, and some pliers will be required. A knife and a pencil with a tape for measuring purposes will obviously help you with your course. If your sink a metal one some little screw clips will do the job to hold it on to the wall. If it is an over mount sink then the problems are solved for some extend as you won’t need anything else to hold it.

Meauring the bathroom vanity cabin is essential before buying a bathroom sink. How to install a bathroom sink to the vanity cabin? Well you will need to make the proper hole or buy the correct size of sink. With less job to do in drilling, a pedestal type bathroom sink will be much easier to install.

It is essential that you clean off whatever dirt on the surface you are going to mount the sinker on to. It will make sure to add some durability to the sinker. With the use of caulking or bolts you should make sure to fix the bathroom sink on a proper grip. Fixing the drain is the next step. To avoid any future problems, apply some caulking on the drain rubber gasket as well. You can then attach the inlet of hot water and cold water to the bathroom sink.
It will come in handy if you do a little bit of research on how to install bathroom sink”. You may well find some additional information in the internet and be a better practitioner at home on how to install a bathroom sink.